Block Ladder Mesh /Deformed Welded Truss Mesh, for Reinforcement Uses

Quick View:
Ladder mesh or deformed welded truss mesh is used as joint reinforcement system for masonry walls in building surface, exterior wall, ground and bridges.

Customized specifications and sizes are accepted

Raw material: low carbon steel and stainless steel wires

Variety: truss-mesh reinforcement, ladder-mesh reinforcement

Surface Treatment:
Welded after hot dipped galvanized
Welded after electro galvanized
Welded before electro galvanized
Welded before hot dipped galvanized
Welded by stainless steel wire

Specifications
Wire Diameter: 2.5-6.0 mm
Width: 5cm,10cm,15cm,20cm
Length: 3mm
Spacing: 40cm
Customized specifications and sizes are accepted
Package: carton/pallet/plastic wrapped

Feature:
The welding spots of warp wire and weft wire are on the same surface; Reducing cracking , increase lateral flexural strength, increase elasticity.

Uses:
We specialize in innovative products for the building industry. XiaoYong Products provide substantial time and cost savings over the traditional work methods. Mainly used in building surface, wall, ground, bridge, bank and airport.

We produce welded wire sheets for reinforced masonry wall construction with specifications and sizes as clients' requirements.

Steel Mesh Deformed for Brick Building Welded Truss Mesh for Masonry Walls